Have a question about programmer/debugger ? Find an answer here.
If you get an error when you try and program using our mikroProg for STM32, then this is a workaround. When you open the mikroProg Suite for ARM, do the following: 1. Disconnect the mikroProg from you...
So, you've bought yourself a new PC and want to use your programmer but you can't find the appropriate drivers? Worry not, as our current drivers will work just fine with the older programmers as well...
If you have, by any chance, an older PIC board and are in need of correct drivers for it, you can find them at the following LINK. Download the drivers and just make sure to install them with administ...
If you have this board and you can't program it, then this is the article for you. After you have finished writing the code and compiling it, connect your board and power it on. Before programming it...
There are two ways of programming the MINI-32 for PIC32MZ. One of them is using the PGC,PGD,MCLR lines and the other one using our USB HID Bootloader tool. However, in order to be able to program it v...
After you have made proper connections between mikroProg for AVR and Arduino UNO ICSP connector you would need to configure the AVRFLASH window like shown on the picture below....
After you have made proper connections between mikroProg for AVR and Arduino mega's ICSP connector you would need to configure the AVRFLASH window like shown on the picture below....
Try to install appropriate driver explicitly as administrator - right click the driver installation EXE file and choose Run as Administrator....
Our hardware is tested and fully functional on Windows 10. Drivers for Windows 10 can be downloaded on our website. In order to prevent any issue while working on Win 10, make sure to: Install the dri...
This error can appear in the mikroProg Suite when the programmer doesn't recognize the MCU. PIC12F508 is chosen as a default microcontroller. In case you are using some development boards (i.e. EasyP...