When you open the mikroProg Suite for ARM, do the following:
1. Disconnect the mikroProg from your PC;
2. Reconnect it;
3. Click on Options;
4. Select JTAG(even if it is selected already, click on it again);
5. Click OK;
6. Program.
Price :
When you open the mikroProg Suite for ARM, do the following:
1. Disconnect the mikroProg from your PC;
2. Reconnect it;
3. Click on Options;
4. Select JTAG(even if it is selected already, click on it again);
5. Click OK;
6. Program.
Strahinja Jacimovic
Comments
herathgayathrie@gmail.com
Hey. Can you tell me how can I use IF on the program? Well I have to do when I click the switch the program must start and when I click again it must turn off. I tried to use *BUTTON == 1* but it gives me an error telling that *1* can’t put.
jasonmbeamer@hotmail.com
Does not work. the mikroprog says "Your Frimware is not up to date, do you want to upgrade your firmware?"
박중현
Error occurred on board porg in mikromedia7 for STM32F4. what should I do?